(2) Maintenance code. Maintenance codes are
1 . Scope
This manual lists spares and repair parts; special tools;
assigned to indicate the levels of maintenance
special test, measurement, and diagnostic equipment
authorized to USE and REPAIR support items. The
(TMDE), and other special support equipment required
maintenance codes are entered in the third and fourth
for performance of organizational, direct support, and
positions of the Uniform SMR Code format as follows:
general support maintenance of the AN/TMQ-5C. It
(a) The maintenance code entered in the third
authorizes the requisitioning and issue of spares and
position will indicate the lowest maintenance level
repair parts as indicated by the source and mainte-
authorized to remove, replace, and use the support
item. The maintenance code entered in the third posi-
tion will indicate one of the following levels of mainte-
This Repair Parts and Special Tools List is divided into
the following sections
O -Support item is removed, replaced, used at the
II. Repair Parts List
of spares and
repair parts authorized for use in the performance of
F -Support item is removed, replaced, used at the
maintenance. The list also includes parts which must
direct support level.
be removed for replacement of the authorized parts.
H -Support item is removed, replaced, used at the
Parts lists are composed of functional groups in
general support level.
numeric sequence, with the parts in each group listed
in figure and item number sequence.
(b) The maintenance code entered in the fourth
b. Section III. Special Tools List Not applicable.
position indicates whether the item is to be repaired
and identifies the lowest maintenance level with the
Number Index. A list, in National item identification
capability to perform complete repair (i.e., all
number (NIIN) sequence, of all National stock numbers
authorized maintenance functions). This position will
(NSN) appearing in the listings, followed by a list, in
contain one of the following maintenance codes:
alphameric sequence, of all part numbers appearing in
the listings. National stock numbers and part numbers
O -The lowest maintenance level capable of com-
are cross-referenced to each illustration figure and
plete repair of the support item is the organiza-
item number appearance.
F -The lowest maintenance level capable of com-
3. Explanation of Columns
a. Illustration. This column is divided as follows:
plete repair of the support item is the direct
(1) Figure number. Indicates the figure number of
the illustration on which the item is shown.
H -The lowest maintenance level capable of com-
(2) Item number. The number used to identify
plete repair of the support item is the general
item called out in the illustration.
b. Source, Maintenance, and Recoverability (SWR)
D -The lowest maintenance level capable of com-
plete repair of the support item is the depot
(1) Source code. Source codes indicate the manner
of acquiring support items for maintenance, repair, or
Z -Non reparable. No repair is authorized.
overhaul of end items. Source codes are entered in the
(3) Recoverability code. Recoverability codes are
first and second positions of the Uniform SMR Code
assigned to support items to indicate the disposition ac-
format as follows
tion on unserviceable items. The recoverability code is
entered in the fifth position of the Uniform SMR Code
PA -Item procured and stocked for anticipated or
format as follows:
XD -A support item that is not stocked. When re-
quired, item will be procured through normal
Z -Nonreparable item. When unserviceable, con-
demn and dispose at the level indicated in posi-
Cannibalization or salvage maybe used as a
O -Reparable item. When uneconomically reparable,
source of supply for any items source coded
condemn and dispose at organizational level.
above except those coded XA and aircraft
F -Reparable item. When uneconomically reparable,
support items as restricted by AR 700-42.