TM 11-6660-266-13
Sectlon II - MAlNTENANCE PROCEDURES
Page
SECTION CONTENTS
GENERAL ......................................................................................................................
INSPECTION ..................................................................................................................
CHECKS/ADJUSTMENTS/ALIGNMENT .......................................................................
REMOVAL AND INSTALLATION ...................................................................................
CLEANING .....................................................................................................................
TEST ..............................................................................................................................
THIS EQUIPMENT CONTAINS PARTS AND ASSEMBLIES SUBJECT
TO DAMAGE BY ELECTROSTATIC DISCHARGE (ESD). USE ESD
CONTROL PROCEDURES FOR PROTECTION OF ELECTRICAL AND
ELECTRONIC PARTS, ASSEMBLIES, AND EQUIPMENT IN
ACCORDANCE WITH DOD-STD-1686 CLASS 1 AND DOD-HDBK-263.
3-3. GENERAL.
This section provides the maintenance procedures to be performed by Unit Level Maintenance personnel as
authorized by the Maintenance Allocation Chart (MAC). It includes procedures for:
Inspection
Checks/Adjustments/Alignment
Removal and Installation
Cleaning
Test
3-4. INSPECTION.
The preventive maintenance checks and services that must be performed by Unit level maintenance personnel to
keep the AN/TMQ-38 Meteorological Measuring Set In good operating condition are listed in table 2-6.
3-5. CHECKS/ADJUSTMENTS/ALIGNMENT.
The only adjustment or alignment authorized to be performed at Unit Level is the MARWIN Processor SSTR
adjustment. This adjustment may be required at installation if the MARWIN Processor displays a warning "W12-
Signal Strength Too Low or "W13-Signal Strength Too High'. Perform the adjustment in accordance with TM
11-6660-280-10, Section 2, paragraph 5.6.7.
3-6. REMOVAL AND INSTALLATION.
To remove and replace components authortzed for Unit Level replacement by the MAC, proceed as follows:
3-41
Previous Page
