TM 11-6660-266-13
(8) Fold-up RDF tripod and repack into RDF carrying bag.
d. Disassemble and repack NAVAID Antenna Set as follows:
(1) Disconnect cables W14 and W16 from Antenna Set and MARWIN Processor. Repack cables into case #7.
(2) Disconnect grounding cable from grounding rod; remove grounding rod and repack into case #7.
(3) Disconnect cable A6W2 from directional antenna and antenna switch. Repack cable into case #7.
(4) Remove directional antenna and repack into case #7.
(5) Disconnect cable A6W1 from antenna switch and remove UHF omni antenna. Repack antenna with cable
A6W1 installed into case #7.
(6) Disconnect cable A6W3 from UHF amplifier and antenna switch. Repack cable into case #7.
(7) Remove antenna mast assembly and repack into case #7.
(8) Remove VLF antenna and repack into case #7.
(9) Remove crossarm and repack into case #7.
(10) Fold-up tripod and repack into case #7.
e. Disconnect and repack interconnect cables and grounding cables as follows :
(1) Disconnect grounding cable from Power Supply Unit and grounding rod. Repack cable into case #8.
(2) Disconnect grounding cable from MARWIN Processor and grounding rod. Repack cable into case #8.
(3) Remove grounding rod.
(4) Disconnect cables W7 and W8 from Power Supply Unit and MARWlN Processor. Repackcables into case #8.
(5) Disconnect cable W9 from Power Supply Unit and DCT. Repack cable into case #8.
(6) Disconnect cable W5 from MARWlN Processor and cable W11. Repack cable into case #8.
(7) Disconnect cable W11 from DCT and COMSEC/Radio. Repack cabIe into case #8.
f. Repack Power Supply Unit as follows:
(1) Reinstall cover and secure four cover latches.
(2) Remove Power Supply Unit and repack into case #8.
g. Repack DCT as follows:
(1) Fold-up sunshade and secure with velcro fastener.
(2) Remove DCT and repack into case #8.
2-50
Previous Page
