TM 11-6660-200-14
4-27.
DIAL WINDOW REPLACEMENT. (CONT)
WIND DIRECTION INDICATOR
NOTE
Steps given are typical for all models.
REMOVAL
1.
Remove four screws (1) and washers (2) and remove front panel (3) from indicator case.
2.
While holding indicator (4) against front panel (3), remove four screws (5), lockwashers (6), and ring (7).
3.
While holding front panel (3) face up, remove indicator (4).
4.
Remove dial window (8).
NOTE
Dial window gasket (9) is secured to front panel; replace dial window gasket only if damaged.
INSTALLATION
1.
Place new dial window (8) in light shield (10) and aline indicator studs (11) with holes (12) on front panel (3).
2.
Install ring (7), four screws (5), and lockwashers (6). Tighten evenly.
3.
Install front panel (3) on indicator case.
4.
Install four screws (1) and washers(2).
4-38