TM 11-6660-200-14
4-32.
CONNECTOR HOUSING COVER REPLACEMENT.
MATERIALS/PARTS: Protective cover, NSN 6660-00-612-0028
PRELIMINARY PROCEDURE: Tilt support assembly (para 4-12).
NOTE
T-420/GMQ-11 and T-420 B/GMQ-11 have a different type of connector housing cover. Replacement
procedures are covered in installation of flexible interconnection cable to connector housing (para 4-8).
If bracket is to be removed along with cover, perform steps 1 and 2. If cover is to be removed alone, perform
step 2 only.
REMOVAL
1.
Remove screw (1) and lockwasher (2) and remove assembly.
2.
Remove screw (3) and locknut (4) and remove cover (5).
INSTALLATION
1.
Install screw (3), cover (5), and locknut (4). Do not overtighten. Allow cover to move freely.
NOTE
If assembly was removed, perform step 2.
2.
Place assembly over hole (6) and install screw (1) and lockwasher (2).
FOLLOW-ON MAINTENANCE: Set support assembly upright (para 4-12).
4-43
Previous Page
