TM 11-6660-200-14
4-36.
PREPARATION FOR STORAGE OR SHIPMENT. (CONT)
REMOVING CONNECTOR HOUSING FROM SUPPORT ASSEMBLY
NOTE
Two methods of attaching connector housing to support assembly are used. Removal of both methods are
covered here.
Tapped Connector Housing Shaft
1.
Remove screw (1) from upper mast section (2) and lift connector housing (3) off support assembly.
2.
Install screw (1) in connector housing shaft (4) to prevent loss.
Through Drilled Connector Housing Shaft
1.
Remove screw (5), lockwasher (6), and nut (7) and lift connector housing (3) off upper mast section (2).
2.
Place screw (5) through connector housing shaft (4) and install lockwasher (6) and nut (7) to prevent loss.
4-50