TM 11-6660-200-14
CHAPTER 5
DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
Subject
Section
Page
Repair Parts, Special Tools, TMDE, and Support Equipment....................................................
Direct Support and General Support Troubleshooting Procedures............................................
Direct Support and General Support Maintenance Procedures .................................................
Section I REPAIR PARTS, SPECIAL TOOLS TMDE, AND SUPPORT
EQUIPMENT
Subject
Para
Page
Common Tools and Equipment ..................................................................................................
Special Tools, TMDE, and Support Equipment ..........................................................................
Repair Parts................................................................................................................................
5-1.
COMMON TOOLS AND EQUIPMENT.
A complete listing of common tools and equipment is given in the Maintenance Allocation Chart (MAC), appendix B.
5-2.
SPECIAL TOOLS ,TMDE, AND SUPPORT EQUIPMENT.
There are no special tools or equipment needed to maintain the AN/GMQ-11.
5-3.
REPAIR PARTS.
Repair parts for the direct support and general maintenance of the AN/GMQ-11 are listed and illustrated in the Repair
Parts and Special Tools List (RPSTL) in TM 11-6660-200-24P.
Section II DIRECT SUPPPORT AND GENERAL SUPPORT
TROUBLESHOOTING PROCEDURES
5-4.
GENERAL
The troubleshooting procedures listed in this chapter are not complete in themselves. They supplement the procedures
normally performed at lower maintenance levels.
To troubleshoot the equipment, first assemble the wind measuring set (para 4-4 through 4-19), then check operation of set
(para 2-6). The troubleshooting table does not list all problems that may occur. If your problem is not listed, or if the
procedures given do not correct the problems, report it to a higher category of maintenance.
5-1
Previous Page
