TM 11-6660-200-14
4-8.
TRANSMITTER ASSEMBLY. (CONT)
TRANSMITTER ASSEMBLY, T-420B/GMQ-11
1.
Slide impeller (1) on generator hub (2).
2.
Aline setscrew hole (3) with flat surface on generator hub (2).
3.
Install setscrew (4) and tighten.
4.
Install and tighten other setscrew (5).
4-9
INDICATOR ASSEMBLY.
INDICATOR CABLE CONNECTION, ID-373/GMQ-11 OR ID-373B/GMQ-11
NOTE
Steps given are for models where interconnection cables are hard wired directly to
TB201 inside indicator when being prepared for use.
1.
Remove 3 inches of outer insulation from cable end.
2
Remove enough insulation from wires to solder on terminal ends.
NOTE
For correct soldering methods, refer to TB SIG 222.
3.
Solder a terminal lug to each wire of cable end.
4-12
Previous Page
