TM 11-6660-200-14
Section III PREPARATION FOR USE
Subject
Para
Page
General........................................................................................................................................
Mounting Support Assembly........................................................................................................
Tilting Support Assembly.............................................................................................................
Conduit Interconnection Cable to Connector Housing Installation. .............................................
Transmitter to Connector Housing Installation ............................................................................
Transmitter Alinement .................................................................................................................
Indicator Cabling Installation .......................................................................................................
Indicator Installation.....................................................................................................................
Windspeed Indicator Adjustment for Knots or MPH. ...................................................................
Windspeed Indicator Zero Adjustment, ID-373/GMQ-1 1, ID-373B/GMQ-1 1,
or ID-373C/GMQ-11 ....................................................................................................................
Protective Ground Connection ....................................................................................................
Support Mast Guying...................................................................................................................
Auxiliary Equipment Installation...................................................................................................
4-10.
GENERAL.
This section explains what must be done when equipment is ready to be put in use. It consists of installation instructions
for components and interconnection wiring necessary to make equipment fully operable. Alinement and adjustment
procedures are also included to give a starting point for proper operation of the equipment.
Resources required are not listed unless they apply to the procedure.
Personnel are listed only if the task requires more than one technician.
Radio Repair Tool Kit TK-17/FMQ-1 is used for all procedures.
Procedures apply to all models unless otherwise specified.
Equipment configurations may vary according to manufacturer.
4-15