TM 11-6660-200-14
4-14. TRANSMITTER TO CONNECTOR HOUSING INSTALLATION.
PRELIMINARY PROCEDURE: Tilt support assembly (para 4-12).
1. Position gasket (1) on connector housing (2).
CAUTION
Do not lift transmitter by vane tail or impeller; lift transmitter by center section only.
2. Aline positioning pin (3) on transmitter (4) with hole in connector housing (2).
3. Aline pins (5) on transmitter (4) with holes on connector J1 (6) and push into place.
4. Install four screws (7) and lockwashers (8) and draw down evenly.
FOLLOW-ON MAINTENANCE: Set support assembly upright (para 4-12).
4-20
Previous Page
