TM 11-6660-200-14
4-13. CONDUIT INTERCONNECTION CABLE TO CONNECTOR HOUSING INSTALLATION.
NOTE
For T-420/GMQ-11 and T-420B/GMQ-11, perform step 1. For T-420A/GMQ-11,
perform step 2.
1. Remove four screws (1) and lockwashers (2), and remove connector housing cover (3) and
gasket (4). Go to step 3.
2. Tilt hinged connector housing cover (5) upward and remove gasket (4).
3. Remove pipe plug (6) from connector housing (7). Retain for shipping.
4. Connect conduit (8) to connector housing (7).
5. Using clamps (9), secure conduit (8) to support mast (10).
6. Remove two screws (11) and lockwashers (12).
7. Remove connector J1 (13) from connector housing (7).
NOTE
A substitute cable (app D) must be used for installation with conduit. Cable WM-76/U
will not fit through conduit.
8.
Remove 4 inches (10.16 cm) of outer insulation from cable (14).
9.
Remove enough insulation from wires to solder to connector J1 (13).
10.
Put prepared end of cable (14) into bottom of conduit (8).
11.
Push cable (14) through conduit (8) and out opening on top of connector housing (7).
12.
Loosen screw (15) on connector J1 (13) and separate case (16) and retainer (17).
4-18
Previous Page
