TM 11-6660-200-14
5-9.
WINDSPEED INDICATOR REPLACEMENT. (CONT)
4.
While holding indicator (8) against front panel (3), remove four screws (9), lockwashers
(10), and ring (11).
5.
While holding front panel (3) face up, remove indicator.
NOTE
Removal of dial window (12) and gasket (13) is not necessary unless loose or
damaged.
6.
Remove light ring (14).
7.
Remove four nuts (15), washers (16), and light shield (17).
INSTALLATION
1.
Position light shield (17) on indicator (8) (view A) and install four washers (16) and
nuts (15).
2.
Install light ring (14) on indicator (8).
NOTE
If dial window (12) and gasket (13) were not removed, disregard step 3.
3.
Install dial window (12) and gasket (13) in light shield (17).
4.
Aline indicator studs (18) with holes in front panel (3).
5.
Install ring (11), four screws (9), and lockwashers (10). Tighten evenly.
NOTE
Orange wire (5) is connected to M terminal for miles per hour or K terminal for knots.
6.
Connect orange wire (5) to M or K terminal and brown wire (6) to + terminal.
NOTE
There are three dial lampholders. Step 7 is typical for all three.
7.
Squeeze both lampholder spring tabs together, push lampholder (7) into dial socket, and
release lampholder spring tabs.
8.
Install front panel (3) on indicator case.
9.
Install four screws (1) and washers (2).
5-11