TM 11-6660-200-14
5-11.
VANE TAIL REPLACEMENT.
MATERIALS/PARTS: Vane tail assembly, NSN 6660-00-882-2128
PRELIMINARY PROCEDURE: Remove windspeed generator G1 (para 5-10).
NOTE
All attaching hardware is removed when windspeed generator G1 is removed.
REMOVAL
CAUTION
Care must be taken when removing vane tail from center section as not to bend long
studs.
1.
Remove vane tail (1) from center section (2).
2.
Remove O-ring (3).
INSTALLATION
CAUTION
When installing vane tail in center section, care must be taken to prevent bending long
studs.
NOTE
Install vane tail on opposite side of positioning hole (4).
1.
Install O-ring (3) on center section (2).
2.
Aline two long studs (5) with holes (6) in center section (2) and push into place.
FOLLOW-ON MAINTENANCE: Install windspeed generator G1 (para 5-10).
5-13
Previous Page
