TM 11-6660-200-14
5.16.
TRANSMITTER CENTER SECTION REPLACEMENT. (CONT)
3.
Remove vane tail (para 5-11).
4.
Remove two screws (5) and lockwashers (6).
5.
Remove support assembly (7) from center section (8).
INSTALLATION
1.
Install support assembly (7) in center section (8) with positioning hole (9) facing toward
5/16-inch (0.08-cm) narrow inner lip (10).
2.
Install two screws (5) and lockwashers (6).
3.
Install vane tail (para 5-11).
4.
Install windspeed generator G1 (para 5-10).
CAUTION
Do not lift transmitter by tail or impeller; lift transmitter by center section only.
5.
Install transmitter (3) on connector housing (4), alining pin (11) with alinement hole in
connector housing and push into place.
6.
Install four screws (1) and lockwashers (2).
FOLLOW-ON MAINTENANCE: Set support assembly upright (para 4-12).
5-21
Previous Page
