TM 11-6660-266-13
(8) Install grounding cable as follows:
ENSURE THAT NAVAID ANTENNA SET IS PROPERLY GROUNDED
TO PREVENT ELECTRICAL SHOCK.
(a) Locate a point of ground as near as possible to antenna sat tripod.
(b) Drive grounding rod into ground by striking rod with sledgehammer until approximately 4
inches of rod remains above ground.
(c) Clamp grounding cable to grounding rod.
(9) Connect antenna set to MARWIN Processor as follows:
(a) Remove cables W14 and W16 from case #7.
(b) Remove protective cover from connector W14P1.
(c) Remove protective cover from VLF antenna amplifier OUT connector.
(d) Connect W14P1 to VLF antenna amplifier OUT connector.
(e) Remove protective cover from connector W16P1.
(f) Remove protective cover from UHF antenna amplifier OUT connector.
(g) Conned W16P1 to UHF antenna amplifier OUT connector.
(h) Remove protective covers from MARWIN Processor ANTENNA and LOCAL VLF connectors.
(i) Remove protective cover from connector W14P2.
(j) Connect W14P2 to MARWIN Processor LOCAL VLF connector.
(k) Remove protective cover from connector W16P2.
(I) Connect W16P2 to MARWIN Processor ANTENNA connector.
2-32
Previous Page
